PDT-GA
 Nuclear Pad Deployment Tool

PDT-GA
Pad Deployment
Tool

PDT-GA.png

 
PDT-GA
Pad Deployment
Presentation

 

PDT-GA Presentation.png

 

 

 

PART No: 10252 – 4410

DESCRIPTION

The PDT-GA is the mandrel used to deploy the Dual Neutron Pad (DNP), or Lithology Density Pad (LDP).  The PDT can be configured to run in the eccentric mode to prevent caliper collapse in deviated wells. Caliper assembly is included.

SPECIFICATIONS

Parameters
English
Metric
Pressure
20,000 PSI
1,379 bar
Temperature
350° F
177° C
Weight
160 lbs
72.5 kg
Tool Length
9.72 ft
2.96 m
Transport Length
11.53 ft
3.51 m
Tool OD
4.84 in
12.29 cm
1 From end of top thread protector to end of bottom thread protector.
 

COMBINABLE WITH

The PDT-GA is used to deploy the Compensated Neutron Pad or Lithology Density Pad. The combined tools are placed anywhere below the Gamma Ray/Spectral Gamma Ray (GRT), but above the Phased Induction (PIT).

REMARKS

Using jigs with known inside diameters of 6 and 12 inches, calibrate the calipers.

For information on Parts, Test, Calibration and Accessory equipment available for the PDT-GA, contact your Tucker Technologies Technical Sales Representative.

LOGGING PARAMETERS

 
Parameter
English
Metric
Vertical Resolution – Caliper
0.2 in
0.5 cm
Measurement Range:
Caliper (PDT)            4.8 in to 22 in (12.2 cm to 56 cm)
Maximum Logging Speed
60 ft/min
18.3m/min
Repeatability
Caliper
 
±0.2 in, ±5.1 mm
Borehole Ranges:
Minimum
6.0 in
15.2 cm
Maximum (PDT)
22 in
55.88 cm
 

BOREHOLE ENVIRONMENT

Open, cased, fluid- or air-filled holes; oil or salt-based muds.

 This site and all material contained in it are considered confidential and may not be
reproduced in any form without written consent from TES.
© Copyright 2017 Tucker Energy Services  |  All Rights Reserved
Follow Us on...